Decals removal ?

[REELBLESSED]

That 3M Stripe Wheel looks great I will have to try it on the outside of the boat on the big stripes. Thanks Cheesegrits 

[Onebadscooter]

As suggested above, a hair dryer worked fine to warm up the adhesive on unwanted decals on the sides of my hull.  Easily scraped off and the remaining adhesive came off quickly w/ a little acetone.

MW

[REELBLESSED]

Thanks onebadscooter

[proline crazy]

A little late, but from Big City Images website:

Decal Removal Instructions
1 - Warm up the old graphic with a hair dryer or heat gun. DO NOT OVERHEAT! Overheating will cause blistering of the paint or the bodywork.

2 - Starting at a corner, slowly peel back the old graphic continually warming the vinyl as you proceed. If the old graphic tears, simply start again until complete removal is achieved.

3 -After the Graphic is removed you can remove any remaining adhesive with mineral spirits, or a citrus based adhesive remover. DO NOT USE LAQUER

[dmarent1]

i just removed all the pinstripe and proline decal,they where bad shape i will replace them soon.i tried heat gun wd40 and goo b gone,it was very slow ,talk to a friend who does body work on cars,told me to try 3m pinstripe remover wheel.it is made of rubber like a eraser i used two wheels to remove all my stripes, numbers and proline name on 23wa .it took me about 3 hours .you have to try this.you will never use anything else after you try one.the wheel cost 20.00 ,and use electric drill.good luck

There aren't any users online.